✓ 5-Year Complete Blast Pot Warranty  |  ✓ 10-Year Pressure Vessel Warranty

Features & Benefits

• 8.0 CU. FT. Capacity (225 Liters)
  • Upper Chamber - 3.25 CU FT (2.69 Useable) Lower Chamber - 4.19 CU FT (4.04 Useable)
  • 150 PSI Vessel (10.3 BAR)
  • A.s.m.e. Section Viii Division 1
  • CRN For All Provinces
• Dual-chamber System
  • Continuously Refills While Remaining Pressurized
  • Increases Productivity By Eliminating The Need To Stop Blasting While Refilling
• BIG GUN Full Flow Systems Provides
  • A Zero Pressure Drop Path For Air & Abrasive To Travel To The Blast Nozzle. Every 1 PSI Gained Or Lost In Abrasive Blasting = 1.5% Production
  • A Must For #7 & #8 Nozzles
  • Full Port Coupling Blast Hose Connection Provides An Unrestricted Path For Air & Abrasive To Travel To The Nozzle
• Dual-chamber Cycle Controls Housed In A Nema 4 Rated Enclosure
• Galvanized Piping For Corrosion Resistance
  • 1-1/2" Piping
  • 2" Inlet
• Heavy Duty Full Port Ball Valves
• Extended Life Schedule 80 Heavy Duty Nipple
  • Withstands Abrasive Wear For Longer Life
• Bolt Clamps On Pusher Line Make Field Repairs Easier
• Combination Valve/apvii Valve
  • Combination Valve Is A 2 In 1 Design That Is Responsible For Cycling The Top Chamber In Dual-chamber Systems
  • Automatic Plunger Valve Ii (apvii) Premium Abrasive Metering Valve With Quadruple Plunger Seal Arrangement Solves The Air & Abrasive Carry Over Problem As Well As The Plunger & Seal Jamming Problem Normally Associated With Regulated Low Pressure Blasting Applications And Or The Use Of Steel Abrasive. Solid Machined Tungsten Carbide Plunger & Sleeve Provides Far Superior Wear Rates And 100% Consistent Tolerances. 1" NPT Cleanout Port Gives Access To Obstructions That May Be Bridging Over The Metering Port Also Allows You To Drain The Vessel Without Removing The Valve
  • Relieving Control Handle Reduces Air Consumption And Reduces Stopping Times When Control Handle Is Released
• 15' Blowdown Hose Assembly For Remote Mounting
• 9" Adjustable Spider
  • Fully Adjustable For Different Media Types & Sizes
  • When Abrasive Is Hopper Feed From Above This Keeps The Weight Of The Abrasive Off The Pop-up Allowing It To Close & Seal Properly
• Skirted Pop-up Gasket
  • Skirted Pop-up Gasket By Design Will Knife Its Way Through The Abrasive To Assist In Sealing
  • Helps With The Abrasive Burping Problem That Is Commonly Seen With Hopper Feed Blast Pots
  • A Must When Using Large Grit Sizes
• Union End Ball Valves
  • Allows You To Shut Off The Abrasive At The Bottom Of The Pot For Maintenance/repairs And Remove The Abrasive Metering Valve Without Dumping The Entire Vessel Of Abrasive On The Floor N. Full Load Lifting Eyes
  • Allow Lifting And Transportation Of Vessel For Placement Maintenance Or Repair